I have a 2005 Equinox with a bad DRL (daytime running lights)resistor. has anyone out there replaced this part themselves? I hear it is located behind the front driver side wheel well.

Can someone let me know how difficult it is to change? I'd like to do this myself andneed a bit of guideance.

Thanks in advance,
Buchu

Ok look at this below


[hr]
[/align]
Daytime Running Lamps (DRL) Resistor Replacement [/align]
http://gsi.xw.gm.com/image_en_us/gif/000/001/863/1863535.gif






Callout

Component Name


Preliminary Procedure
Remove the front bumper fascia. Refer to Front Wheelhouse Liner Replacement (http://gsi.xw.gm.com/si/cellHandler.do?cellId=9398&refDoc=1863966&from=sm) .


1

Forward Lamp Wiring Harness Assembly


2

Daytime Running Lamp Resistor Assembly Bolt
Notice: Refer to Fastener Notice (http://gsi.xw.gm.com/si/cellHandler.do?cellId=10105&refDoc=1863966&from=sm ) in the Preface section.
Tighten
6N·m (53lbin)


3

Daytime Running Lamp Resistor Assembly
Procedure
Disconnect the electrical connector.[/align][/align]

Thank you very much! The picture is exactly what I needed.

Does anyone know where I can buy this resistor online? I've looked at GMpartsdirect but all they have is the bolt.

Thanks for your help!!