General TechGood at troubleshooting? Have a non-specific issue? Discuss general tech topics here. IF YOUR QUESTION IS SPECIFIC TO A CERTAIN MODEL, IT DOES NOT GO IN THIS SECTION.
Welcome to Chevrolet forum!
Welcome to Chevrolet forum,
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Chevrolet forum today!
I have no heat on driver's side but passenger side works perfectly. The service manual shows three actuators; one left, one right and one called the mode. I located the left (driver side) actuator under the dash and was able to pull the lever completely to the bottom, which is presumably the "full heat" position. The control was in the highest heat position, but when I started the engine, the lever went all of the way back to the top, and continued to blow cold air.
Questions: 1) Does anyone know which of the three actuators controls the driver's side heat? 2) Does the fact that the left actuator returns to the "cold" position indicate that it may be in the "control" rather than in the actuator?
Thanks for any assistance.
Register today for free or log-in if already registered to remove this ad!
Last edited by kenintally; 02-06-2011 at 05:01 PM.