Valve job
#1
Valve job
I know that a jeep guy doesnt belong here but my 86 jeep Cherokee has a 2.8 V6 and I believe it needs a valve job.I just got this jeep a few months ago from a friend (some friend) but it was free and virtually rust free and a great interior. The jeep sat for almost 5 years with the occasional start. It has a ping rattle in the upper driver side of motor and burns a good amount of oil. To get to the point what does it roughly cost for a valve job? Or does anybody have any suggestions on what to check? Really thankful for help.
Joe
Joe
#2
RE: Valve job
I believe that 2.8 is a GM motor used in some CJ's .....You could google around in Jeep boards as some of these CJ Jeepers have been working with these motors I'm sure.
Thread
Thread Starter
Forum
Replies
Last Post
MissionValley
Silverado & Fullsize Pick-ups
1
April 2nd, 2014 1:55 PM
454BBC
Silverado & Fullsize Pick-ups
1
April 30th, 2013 5:48 PM
83_Caprice_Classic
General Tech
3
September 21st, 2010 2:12 PM