kimi_bessel

I have a new clutch master and slave cylinder and tranny bench bleed the slave bleed the system but now I have noticed that the clutch forks are not pushing the rod for the slave cylinder at all clutch disengages enough to start my truck but I cant put it in gear I can start it in gear but it jumps forward and I have to shut it off quickly if in gear it will cut out and suggestions

73shark

Welcome to the forum.

You will get more views if you post your question in the section of the forum dealing with your vehicle.

oldchevy

If there are no leaks, then bleed it several more times to get all the air out.