New to forum! Need wiring help!
#1
New to forum! Need wiring help!
Hi, new to the forum and looking for some help! I have a 1963 Chevy Panel Truck that I'm building from the ground up to lay on the ground. It's bodydropped on 84 axles. I am running a drivetrain from a 95 RV which was based off a G30 van. It had a TBI 350 with a 4L80E tranny.
I have the drivetrain in my 63 and have it running with the 95 RV column laying on the floor. I need to wire the ignition from the g30 harness into the ignition of the 63. I also need to wire in the turn signals. The rest I think will work.
Can anyone help me with a wiring diagram of the ignition and turn signals for a g30 van or truck equivalent? I'm guessing the wiring is pretty similar if not the same for a 95 truck with TBI.
Thanks in advanced.
Here's a pic of my panel truck.
I have the drivetrain in my 63 and have it running with the 95 RV column laying on the floor. I need to wire the ignition from the g30 harness into the ignition of the 63. I also need to wire in the turn signals. The rest I think will work.
Can anyone help me with a wiring diagram of the ignition and turn signals for a g30 van or truck equivalent? I'm guessing the wiring is pretty similar if not the same for a 95 truck with TBI.
Thanks in advanced.
Here's a pic of my panel truck.
#4
Thread
Thread Starter
Forum
Replies
Last Post
navarro
New Member Welcome Area
1
October 20th, 2012 10:20 PM
hondaman69
New Member Welcome Area
5
November 8th, 2009 7:15 AM