Oil filter adapter lines 99 blazer
December 30th, 2008, 6:26 PM
#1
CF Beginner
Thread Starter
Join Date: Dec 2008
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Oil filter adapter lines 99 blazer
I am replacing the lines that run from the oil filter to the engine block. I got the bolts out but cannot remove the old line. The rear fitting is too large to fit between the engine and the axle. I have seen one recommendation to cut the rubber section of the lines and that would work, but I am worried about getting the new line in there. There has to be a trick to this. Please help!
December 31st, 2008, 1:21 PM
#3
CF Beginner
Thread Starter
Join Date: Dec 2008
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
RE: Oil filter adapter lines 99 blazer
Thanks,
We did jack up the engine. Just needed jacked up a hair to get enough clearance so we did not have to unbolt the mount.
We did jack up the engine. Just needed jacked up a hair to get enough clearance so we did not have to unbolt the mount.
Thread
Thread Starter
Forum
Replies
Last Post
burbandad
Tahoe & Suburban
1
December 19th, 2010 12:11 AM
