small block nut

hey guys. this is only my second time on the site but all skip the hey how are ya's and get to the point. a have two pickups now.a 1996 chevy silverado ful load with a 350 ton out with complete magnaflow exhaust and a large number of other upgrades. my second one is a 1994 1500 sierra sle full load. i inheritted it from my grandfather who was a farmer. the truck has 168000 kilometers on it but the body is rough as hell considering it was a fram truck. im planning on doing a complete body job on it including engine/tranny/ transfer case out a complete frame sand blast and all new panels. i think i have covered almost all the basics. im planning on doing the prep work myself but sending it out to get painted. any other suggestions or options i should do that will cover any other areas. keep in mind i live in canada and have winters with salt on the roads.

redneck 4 life

well with the salt id get a set of dimond plate mud flaps but u probly were getting some of them, also with the salt i have seen people put spary on bed liner down under the side molding and the bottom of the rockerpanles. wat r u going to drop in for an engine? stay with the 350 or good bigger?

P.S. the sierra is GMC not CHEVY