varmint
04-19-2007, 09:18 PM
I have a low mileage (55,000) astro AWD that has the following problems...in order of importance....
1) The vehicle front end bucks and clunks when I attempt to make a turn, either left or right,.....when I straighten out the wheels, it goes away and vehicle is fine...this happens at slow speeds and while I park...basically any time I cut the steering wheel, there's a drive-train thump....I'm guessing CV joint/axle? I changed lube in both front & rear diffs....How would I go about diagnosing this problem? I have access to a lift...
2) Vent AC/Heat control not working....The fan speed settings work perfectly, as does the hot/cold switch....Problem is in the far right (on dash) vent control switch...it's blowing out the defroster & heater no matter where I put the switch....I had the doghouse off and didn't see any frail, rubber hoses that could've crack or otherwise failed...everything is either hard plastic or steel vacuum lines... Any help would be appreciated on this....
3) driver's power window works, then stops.....wait a while and it'll go up a few inches (or down) then stop again....Could this be the motor?
Sorry for the three questions....but I really love this van and want to get it back to working order...
Thanks
1) The vehicle front end bucks and clunks when I attempt to make a turn, either left or right,.....when I straighten out the wheels, it goes away and vehicle is fine...this happens at slow speeds and while I park...basically any time I cut the steering wheel, there's a drive-train thump....I'm guessing CV joint/axle? I changed lube in both front & rear diffs....How would I go about diagnosing this problem? I have access to a lift...
2) Vent AC/Heat control not working....The fan speed settings work perfectly, as does the hot/cold switch....Problem is in the far right (on dash) vent control switch...it's blowing out the defroster & heater no matter where I put the switch....I had the doghouse off and didn't see any frail, rubber hoses that could've crack or otherwise failed...everything is either hard plastic or steel vacuum lines... Any help would be appreciated on this....
3) driver's power window works, then stops.....wait a while and it'll go up a few inches (or down) then stop again....Could this be the motor?
Sorry for the three questions....but I really love this van and want to get it back to working order...
Thanks