You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Chevrolet forum today!
Hello I just bought a 85 K5 Blazer. The back window would not go down. When you hit the power window switch you could hear the motor but still nothing. Found out the window regulator cable was discounicted. So I conected it and it went down, but it will not go up. If I hit the switch for the window to go up nothing. Please help.
Register today for free or log-in if already registered to remove this ad!
Is there a manual way to get my back window back up? Motor works going down but hit the switch for it to go back up and nothing. Do you think it could be the power switch? Please help.fficeffice" />>> >>
I tried that and it did not work. So I thought it needed to go all the way down for it to go back up. Is there a release button or switch to unlock the window or even a way to crank it up?
i had that problem on mine. try checking the ground. mine was grounded to go down. but when i went to raise it up nothing. checked the ground and it was it.
Is there a manual way to get my back window back up? Motor works going down but hit the switch for it to go back up and nothing. Do you think it could be the power switch? Please help.fficeffice" />>> >>
take the inspection cover off and unscrew the cable from the rear window motor,once the cable is loose take some visegrips and grab the cable end and turn ...the window will open or close depending on direction turned...yea might just be in the switch...but this will work till you figure ot out!...........ive had this happen(fun fun )
Had that problem before.. window regulator cable disconnected so I had to check the wires and all that.. But it's not fixed yet so I push up the window while someone is pressing the button.
I drilled a hole in my inspection and stuck the end of the cable thru, I just use a drill to open and close it. I had a working motor in it but my switch was no good, it was always in the up position and eventually it burnt my $55 motor out.
K5 Rear Window
ffice" />
