Control arm
#1
Control arm
I am replacing front shocks but when trying to remove lower bolts on lower control arm they broke off. Was able to salvage one by drilling but the second one is a mess as the drilling started at an angle and ended up drilling too close to the edge. can it be grinded back towards the center to fit but having a bigger hole than original? any suggestions on how to proceed?
Thread
Thread Starter
Forum
Replies
Last Post
Muskovin
Silverado, Sierra & Fullsize Pick-ups
2
February 24th, 2013 5:13 PM
maxxman04
Silverado, Sierra & Fullsize Pick-ups
1
March 9th, 2010 5:34 PM
waitery
Silverado, Sierra & Fullsize Pick-ups
0
June 30th, 2009 4:29 PM