Advice about machine shops...
#1
Advice about machine shops...
Hi there I have a 375 hp 396 that was bored 30 over and ran well for a little bit, now im getting smoke it has the 10.5to 1 pistons in it, any good machine shops that you guys can recommend in southern California to go thru my motor and also blueprint and balance and fix the blow by. im in the inland empire, the last machine shop i took it to was not very competent. i like the shop to do the work and also would like the engine back put together except the intake manifold. also around what range you guys think itll cost me? the motor runs right.
Thanks for your time for reading this post.
Thanks for your time for reading this post.
Thread
Thread Starter
Forum
Replies
Last Post
tom5170
General Tech
5
November 28th, 2010 11:41 AM
Skylan
Silverado, Sierra & Fullsize Pick-ups
3
April 16th, 2009 11:56 AM