chevy 350 in a bronco
#1
chevy 350 in a bronco
hey guys, looking for some guidance, i recently purchased a 1973 ford bronco with a 350 in it i am doing a painless wiring harness on it and the harness is built for a ford engine, any tips, diagrams or suggestions on how to deal with the engine component of this? I have the HEI so from what i understand no need for ballast resistor, voltage deal, coil and the selonoid set up is obviously different. I am completely ignorant to anything electrical other than following instructions and road maps, any input is greatly appreciated!
#2
CF Monarch
hey guys, looking for some guidance, i recently purchased a 1973 ford bronco with a 350 in it i am doing a painless wiring harness on it and the harness is built for a ford engine, any tips, diagrams or suggestions on how to deal with the engine component of this? I have the HEI so from what i understand no need for ballast resistor, voltage deal, coil and the selonoid set up is obviously different. I am completely ignorant to anything electrical other than following instructions and road maps, any input is greatly appreciated!
#3
yes it was running well before i gutted the electrical, not sure on the age of anything in it, i put an edelbrock with an electric choke on it and it was sounding great before i started the overhaul
Thread
Thread Starter
Forum
Replies
Last Post