Slave Cylinder Push Pin
#1
CF Beginner
Thread Starter
Join Date: Sep 2021
Location: San Diego
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Slave Cylinder Push Pin
I have a 1986 S10, 2.5L rr wheel drive. I am replacing the slave cylinder but I can't, don't know how to remove the push rod from the clutch fork. Its a straight rod, tapered on both ends. Would just re use it but its got some burs and I don't want to ruin the new part. Can anybody please point me in the proper direction. There's no locking hardware on the rod so it must slide out some how. In advance Thank You.
This is what it looks like, this is the new one
This is what it looks like, this is the new one
#2
CF Beginner
Thread Starter
Join Date: Sep 2021
Location: San Diego
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Slave Cylinder Push Rod
I have a 1986 S10, 2.5L rr wheel drive. I am replacing the slave cylinder but I can't, don't know how to remove the push rod from the clutch fork. Its a straight rod, tapered on both ends. Would just re use it but its got some burs and I don't want to ruin the new part. Can anybody please point me in the proper direction. There's no locking hardware on the rod so it must slide out some how. In advance Thank You.
This is what it looks like, this is the new one
This is what it looks like, this is the new one
Thread
Thread Starter
Forum
Replies
Last Post
cxhxexvxy
Silverado, Sierra & Fullsize Pick-ups
0
August 18th, 2009 2:16 AM