NP246 clutch pack help needed
September 20th, 2018, 9:28 PM
#1
CF Beginner
Thread Starter
Join Date: Jul 2011
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
NP246 clutch pack help needed
I don't remember this on disassembly, but when assembling it, the clutch retaining ring od is very close to the clutch inner bearing inner support id. Matter of fact, when not on the shaft the ring will almost slide into the bearing support. It just doesn't seem like there's enough "meat" to hold the bearing support in place. What am I missing here??? Thanks!
September 21st, 2018, 2:42 AM
#2
CF Monarch
I don't remember this on disassembly, but when assembling it, the clutch retaining ring od is very close to the clutch inner bearing inner support id. Matter of fact, when not on the shaft the ring will almost slide into the bearing support. It just doesn't seem like there's enough "meat" to hold the bearing support in place. What am I missing here??? Thanks!