Hello everyone, I might be in over my head on this project but im going to do it anyways. I need to replace the blend door actuator between the firewall and blower.man is that thing really tucked up in there. I am completely stumped on even where to start. does anyone have a chilton they could copy a page or two for me that could send me in the right direction? Thanks in advance.

 

Check YouTube, there should be some videos on how to do this.

 

I have searched all over. closest i found was someone disconnecting the wires of it. there 3 on my truck and the one is a complete nightmare and theres no videos that i could find of the specific one. and i think i have to tear stuff out of the way first. just not sure where to start.

 

I just watched some youtube videos on it. You are right, they don't show the removal. Though, if you read into the comments section. There is plenty of info there.
One specifically stated "go through the glove box to get to it". A second commentator seconded that statement. So, maybe you can look at getting to it from there.
As for removal, it looks hard but doable. It is the top screw that people are complaining about. That is why they stated to go through the glove box.