1988 - 1998 (GMT400) Section for all discussion related to the 1987-1998 Chevrolet and GMC trucks.

ECM issues

Old Oct 28, 2021 | 12:17 AM
  #1  
Bill Bryson's Avatar
Thread Starter
CF Beginner
 
Joined: Oct 2021
Posts: 1
Likes: 0
From: Pennsylvania
Default ECM issues

Intermittent code 13 issues with code 22. Replaced both O2 sensor and TPS....twice! Still trips these codes and truck surges, idles over 1000rpms, shifts hard from 1st to 2nd. Resets when parked for 10 mins and runs fine for awhile, then O2 trips...and goes away few minutes later. Then code 22 trips, and runs bad. Exhaust is new from headers back. Also replaced idle Air Control valve. Can't figure it out. And coolant temp sensor on intake is new too. Help!?!?!?
Reply
Old Oct 30, 2021 | 10:16 AM
  #2  
Sabino56's Avatar
CF Active Member
 
Joined: Jul 2018
Posts: 134
Likes: 12
Default

You say “headers”? W.r.t. the 13 -This is getting outside my experience but if you put on headers you may need a heated O2 and/or be careful on where you place it. Perhaps ask on gearhead-efi where the tuners hang out. Good luck!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Edawg2009
Other
6
Apr 15, 2021 4:21 PM
OldBurban
Tahoe & Suburban
7
Oct 30, 2020 8:44 AM
Steverenio
Impala
1
Nov 25, 2017 4:03 PM
Mark Longo
1999 - 2006 (GMT800)
7
Feb 17, 2017 7:34 PM
thomis
S-10 & Blazer
1
Oct 23, 2012 4:12 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 8:16 PM.