Installing a cruise control in 2010 Cobalt.
May 21st, 2012, 2:48 PM
#1
CF Beginner
Thread Starter
Join Date: May 2012
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Installing a cruise control in 2010 Cobalt.
Hi all
I am looking to have a cruise control installed in my 2010 Cobalt. After doing some research on the internet I found that I need a Rostra 250-9600, as my vehicle was manufactured in May of that year or least that is what is listed on the inside panel of the front drivers side door. I have been told by a few of the retailers offering this item on the internet that is very easy to install. This thing is really not my cup of tea, so I found someone that will install it if I provide the part, but he seems to think it will take 2 to 3 hours to complete. While the time needed to complete this does not indicate the ease of installation, this time estimate seems a little much. Was hoping that someone else out there has had experience with this on the make and model.
Thanks
Michael
I am looking to have a cruise control installed in my 2010 Cobalt. After doing some research on the internet I found that I need a Rostra 250-9600, as my vehicle was manufactured in May of that year or least that is what is listed on the inside panel of the front drivers side door. I have been told by a few of the retailers offering this item on the internet that is very easy to install. This thing is really not my cup of tea, so I found someone that will install it if I provide the part, but he seems to think it will take 2 to 3 hours to complete. While the time needed to complete this does not indicate the ease of installation, this time estimate seems a little much. Was hoping that someone else out there has had experience with this on the make and model.
Thanks
Michael
Thread
Thread Starter
Forum
Replies
Last Post
soohill
Silverado & Fullsize Pick-ups
2
November 4th, 2013 11:06 PM
