crank sensor problem help please
#1
crank sensor problem help please
Hi all nice to find such a wealth of info I have been searching did find some info on my issue just need to ask a little more.
So here it goes I tried to pull crank position sensor out of my 1999 suburban 7.4 well it broke in half so after searching and reading
I ran a screw in the piece and it pulled out but oh yeah the but lol. when looking up in the hole it has a brass or at least looks like brass sleeve still in there Does that need to come out or does it stay?
I figure it needs to come out but thought it best to ask first and if it needs to come out any suggestions on how to get it out. can i run a screw like i did the other.
do all these crank sensors break like that only ask because I was going to just pull on out of another truck but not if it will break off.
Thanks for the help.
So here it goes I tried to pull crank position sensor out of my 1999 suburban 7.4 well it broke in half so after searching and reading
I ran a screw in the piece and it pulled out but oh yeah the but lol. when looking up in the hole it has a brass or at least looks like brass sleeve still in there Does that need to come out or does it stay?
I figure it needs to come out but thought it best to ask first and if it needs to come out any suggestions on how to get it out. can i run a screw like i did the other.
do all these crank sensors break like that only ask because I was going to just pull on out of another truck but not if it will break off.
Thanks for the help.
Last edited by notagain; June 10th, 2013 at 8:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
JimOmaha
Silverado, Sierra & Fullsize Pick-ups
7
November 12th, 2022 7:26 PM
nwodeville76@hotmail.com
General Tech
1
October 5th, 2012 10:22 AM
fish2222
Silverado, Sierra & Fullsize Pick-ups
3
January 11th, 2012 7:05 AM