Leak Down Results on MHG before start up
#1
Leak Down Results on MHG before start up
Still learning here. Should my leak down results be erratic before start up with new MHG? Are heat cycles necessary for proper gasket seal? I'm trying not to complete assembly before deciding whether to deck the block again or do composite gasket. Head was tested, machined .008, new stem seals. Compression was good before dis-assembly. Thanks for sharing your experience.
Thread
Thread Starter
Forum
Replies
Last Post
DerekShiekhi
Silverado & Fullsize Pick-ups
0
August 13th, 2015 5:36 PM
GaryB-2009
Silverado & Fullsize Pick-ups
2
April 11th, 2009 7:24 AM