Chevrolet Forum - Chevy Enthusiasts Forums

General Tech Good at troubleshooting? Have a non-specific issue? Discuss general tech topics here. IF YOUR QUESTION IS SPECIFIC TO A CERTAIN MODEL, IT DOES NOT GO IN THIS SECTION.
Sponsored by:
Sponsored by: CARiD

Spewing water

Thread Tools
 
Search this Thread
 
Old Oct 30, 2018 | 3:39 PM
Share
  #1  
Ron Stiffler's Avatar
Ron Stiffler
Thread Starter
CF Beginner
 
Joined: Oct 2018
Posts: 2
Likes: 0
Default Spewing water
I just put a 383 stroker in my T Bucket, under acceleration it blows water out of cap, cap is new 16# Radiator is 3 core 2 yrs old , themastat is working, no water in oil or oil in water, no leaking any where, previous motor was a 355” sbc no problems. Not that it matters but running Colorado hot rod 2x4 tunnel ram with 2 580 core Quick Fuel carbs..I’m new to the site but been around chevys since 1964,,I run out of ideas..HELP
Reply
0
Old Oct 30, 2018 | 4:57 PM
Share
  #2  
kevinkpk's Avatar
kevinkpk
CF Monarch
10 Year Member
Liked
 
Joined: Jul 2011
Posts: 5,920
Likes: 139
From: kevinkpk
Default
Trying to eleminate this issue, have you run this with the heater on? Assuming it has a heater core, not electric heat.
Reply
0
Old Oct 30, 2018 | 8:15 PM
Share
  #3  
Ron Stiffler's Avatar
Ron Stiffler
Thread Starter
CF Beginner
 
Joined: Oct 2018
Posts: 2
Likes: 0
Default Spewing water
no heater I’m in Fl . Motor doesn’t overheat runs between 165-180 ..
Reply
0
Back to Subforum
General Tech
View Next Unread
Tranny shift sensors




Advanced Search

All times are GMT -5. The time now is 8:47 PM.