2009 Chevy Malibu LTZ 2.4L New CPS Not working
Thread Starter
CF Beginner
Joined: Jun 2019
Posts: 2
Likes: 0
2009 Chevy Malibu LTZ 2.4L New CKP Sensor Not working
I recently bought a 2009 Chevy Malibu LTZ and I thought it would be crankshaft position sensor. I replaced the sensor and still get the code ("P0335"), no tachometer and it runs rough. No obvious damage to the wiring. I was going to us a multi-meter to check continuity of the wire. I'm just not sure where the other end is at. Dose it connect directly to the ecm? If it dose could I possibly have a bad ecm?
Last edited by Bryan Wyandt; Feb 12, 2020 at 2:52 PM.
CF Monarch
Joined: Oct 2017
Posts: 4,605
Likes: 269
From: USA
I recently bought a 2009 Chevy Malibu LTZ and I thought it would be crankshaft position sensor. I replaced the sensor and still get the code ("P0335"), no tachometer and it runs rough. No obvious damage to the wiring. I was going to us a multi-meter to check continuity of the wire. I'm just not sure where the other end is at. Dose it connect directly to the ecm? If it dose could I possibly have a bad ecm?
- Damaged crankshaft position sensor
- Defective crankshaft position sensor
- Broken timing belt or chain
- Rough running/misfiring engine
- Failed ECM
Thread
Thread Starter
Forum
Replies
Last Post
curbsidebullit
Malibu
0
Nov 15, 2017 8:52 PM
