Hey guys, I have a 1953 model 235 for sale,
It has had all the machine work done, and has all the parts to put it together, except, needs the cam and lifters.
Has had the following done.
Rotating assembly was balanced.
Head was maged and decked, new valves, guides and springs, and valve job done, head is ready to bolt on.
Crank was ground,
Block was magnafluxed, decked, and bored and honed, new pistons fit.
cam bearings put in.
Rods where checked, new wrist pin bushings put in.
I have new pistons, rings, and new rod and crank bearings in the box's .
Have new water and oil pumps, complete gasket kit . carb kit .
Have flywheel, and new clutch disk and pressure plate, and throw out bearing .
All this engine needs is a cam and lifters and its ready to build.
I have right at 2k in the machine work and parts, Id take 2500 for it.
I will build it for you if you need help there ..
I have the transmission and starter also ..
Thanks ...

 

Make me a offer, Im tired of walking around this thing ...

 

Still tripping over this thing ...

 

make me a offer guys.

 

Back to the top ...