When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm installing the driver's side suspension after putting in all new bushings and ball joints in a 1980 Chevrolet g20.
The lower control arm has a cross member with a small hole on one side meant to go into a stud on the lower control arm cradle.
I tried my best to rotate the cross member so that the hole would line up with the stud, yet when I go to install it I can't tell if it's lining up, here is a picture
Any ideas, on how to make sure the hole and stud align and go in?
Cross member Dimple Alignment
