wheel hub and ????
May 23rd, 2012, 7:50 PM
#11
pretty sure the complete abs speed sensor and reluctor wheel are all part of the new hub bearing assembly.
the rim scratch:
looks like the rim was hitting the rotor; probably was installed on a vehicle with a bigger brake package or different rim offset.
the rim scratch:
looks like the rim was hitting the rotor; probably was installed on a vehicle with a bigger brake package or different rim offset.
May 25th, 2012, 1:38 PM
#13
CF Junior Member
Thread Starter
Join Date: Jul 2006
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
ok, truck is running good so far, i replaced the wheel hub assembly and the cv axcel shaft.
i went ahead and ordered another wheel hub assembly for the drivers side, i figure it won't take long for it to fail. my question is, should i replace the axcel too?
so my question is, should i have to get it aligned? Its not pulling or anything...
i went ahead and ordered another wheel hub assembly for the drivers side, i figure it won't take long for it to fail. my question is, should i replace the axcel too?
so my question is, should i have to get it aligned? Its not pulling or anything...
May 26th, 2012, 10:58 AM
#15
CF Veteran
Join Date: Feb 2012
Location: nebraska
Posts: 1,433
Likes: 0
Received 0 Likes
on
0 Posts
technically you shouldn't need an alignment after just replacing the hub but I'm assuming it hasn't been done for a very long time since your hub got that bad so it definately wouldn't hurt
Thread
Thread Starter
Forum
Replies
Last Post
Stevoray81
Malibu
7
October 30th, 2014 10:30 PM
hairscrambler
Tahoe & Suburban
6
February 25th, 2014 1:48 PM
