Hello, new to the forum. I have a 98 Chevy Z71. Pulled out the 4L60e and put in a NV3500 and 32 spline transfer case. Just completed the swap, mechanicly everything is running good. Electrically my SES light is on and it is picking up 7 transmission codes. I read in another post that ecm needs re-flashed to manual program? Has anyone done this or figured out a way to get the ecm to stop reading the trans codes? If re-flashed is needed who can do it? Any help?

 

Does anyone have a good schematic of the automatic neutral safety switch mounted to the side of the 4l60e? Or what two wires I would use for the new clutch safety switch?

 

Never mind, got it all figured out, truck runs like a champ now.

 

did you figure out how to get rid of the trans codes? I have the same issue