here is how i did my cb install on my 2001 gmc 2500 hd

i removed the over head console which comes out with one screw and a sharp pull. the side pillar just pulls off. drilled 1 hole in the back of the overhead console for the wiring to run threw. soldered all conections and then warped in e tape. had to take the headliner loose enough to get the wires threw even then had to use a coat hanger to pull them. ran them down the pillar and power into the fuse box and used a fuse tap. only thing i have left to do now is figure out where and how i want to clip my mic, I'm going to run it as is for a bit and see where will work best.

















total probably took me about 2 hours im very happy with the install, other than how the mic cord hangs but im not sure where and how i want to hang it yet so its just dangling for now.

 

Why not just install the clip on the left or right outer side of the overhead console and clip it there?