I have an 08 silverado reg cab 4x4 with a 4.8l. Last week I was driving up a hill and the truck shut off. Assuming it was the fuel pump I went ahead and replaced it. Wasn't the problem turned out the FSCM was bad it kept blowing the fuse. Replaced it, the fuse no longer blows but I'm still not getting any fuel pressure. I work during the week and really don't have time to work on it so this weekend I'm dropping the tank again and checking my pump again but I would like some opinions before I do all that again. Any suggestions??

 

is this a used module from a boneyard?


New, replacement modules need programming...one from a different vehicle will probably need programming also.

 

It's a new module would a dealer have to program it if so do you know a price range?

 

yep, it needs programming by the dealer. my shop would charge 1hour labour...total charge depends on the shops door rate.

 

Thanks for the heads up hopefully it's saved me a lot of unneeded work