Spare tire access tube retainer clip and ring
#1
Spare tire access tube retainer clip and ring
I am stumped and frustrated... I recently disassembled my rear bumper and installed a new chrome face. It is all done except for the spare tire access tube. Without a doubt, the most difficult challenge of this entire project is the installation of a new retainer set like this I cannot get the dang thing on! Has anyone ever installed one of these? Is there a secret trick? Do I need to flatten out all the tabs and then bend them back once it is installed? I have spent hours and tried everything I can think of.
I would much appreciate any advice!
I would much appreciate any advice!
#2
Never mind... I dug out the old OE retainer from the trash and fortunately it was not in too bad shape. So I cleaned it up and "popped" it on. Took 5 minutes. Anyone replacing their bumper I would recommend NOT buying one of these from the big aftermarket internet store that sells clips and fasteners. They should reimburse me for a half day of labor.
Thread
Thread Starter
Forum
Replies
Last Post
cjfelsinger
Tracker
0
May 27th, 2014 3:46 PM
DeHartShadow
Impala
4
March 26th, 2014 12:47 PM
Kevin8520
Silverado, Sierra & Fullsize Pick-ups
2
August 31st, 2007 3:32 PM