What did you do to/with your Chev. Today
#1
CF Beginner
Thread Starter
Join Date: Apr 2015
Location: Idaho
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
What did you do to/with your Chev. Today
Got this thread from my F#£€ forum but I really injoyed the ideas and this folks do with/to there vehicles so here it is
#2
CF Beginner
Thread Starter
Join Date: Apr 2015
Location: Idaho
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I'll start, i hooked up the small cargo trailer and hauled inventory for my music store to a different store location around 90 miles round trip and burned through about 1/3tank of fuel because of a 29mph head wind
#4
Administrator
Backed it out of the garage, checked the oil, added battery post felt insulators , pulled it back into the garage (have the day off today so not much driving around to do)
Trending Topics
#8
the project
So since the last couple of days i have been busy working on the truck. it all started with the drive shaft u-joints long story i ran around and no shop had time to remove them so i went about doing it myself. the we had to measure and order the same aftermarket u-joints. since i couldnt drive the truck anyways i fiquered i could swap out the rad, which i had gotten a almost new one from my buddys truck which he had blown the trans, got new hoses the when i went out to change the thermostat snap a bolt of in the intake manifold,long story short can get the snapped bolt out so here i am replacing the intake. TBI Intake which are expensive , but the drive shaft is in know with new u-joints
#9
Need to fix mine; a pretensioner code set for the r/f seat. Good timing as I only have 1 more week to access the sir load tools. Leaving gm at the end of the week. Its been a great place to work. I will miss it.
#10
made my own SIR load tool for under $1. disconnected the r/f seat pretentioner connector and plugged in the load tool. Air bag light went off so the pretentioner is bad Quote for a new pretentioner; $210 plus tax new...went to picknpull..$6.85
plugged it in...all good.
plugged it in...all good.