ok people I have 2000 suburban just did the rotors and brake pads ebrake shoes.but now it make noise any ideal what this could be?also replaced the dust shield.also has anyone dual the exhaust out on these suburban?

 

seem now the pass side front make noise when going around curves.

 

If I have the correct picture in mind...

The Rotors inadvertently flex some when cornering, just a nature of minor clearance in the Bearings. Could the Shield be a little too close ?
Probably a little bend with a Screwdriver outward, might correct ?

 

I don't think so fixing to jack it up again and have better look what going on.

 

If it wasn't happening beforehand then I would also guess the dust shield might be contacting the rotor...but that should make noise going straight or turning

 

problem found in rear was the ebrake cable rubbing the tire.