larry_chip

I've seen a few on ebay & in the Sticky Above ^^ "Post the Tahoe Pics" theres a Tahoe with a I Pod Holder, just wondering how those are, i hate because my ipod sits in my cup holder, i've seen those ones on ebay & i thought they we're just cheap rip pffs but i seen that you guys had them.

please post some pics. Thanks,

rat55chevy

Use the Griffin cupholder unit. Pretty handy for $10. Alternately, I have my cup holder in the forward position and sometimes slide it in the gap between the cup holder and the front of the console (at least there it is hidden and protected).

jeffshelton12

I'm also looking for an Ipod holder. While looking around on the net justminutes ago, I found this set up that someone apparently made. This dude could make some serious money if he were to mass produce it. I know I want one but I'm not a welder!!!!!!!!!!!!

http://www.ipodhacks.com/article.php?sid=160

Be sure to check out the 4 pics!

73shark

If you can't weld, try brazing which is like soldering only done on steel. If not that, then the two pieces could be mechanically attached with screws. Barring that, there is always JB Weld.

engine2

Here is one http://cgi.ebay.com/ebaymotors/KUDA-...QQcmdZViewItem




[IMG]local://upfiles/5659/62F8B3F219DF4463B037815BBC4BEAE1.jpg[/IMG]

larry_chip

engine2 Yea thats the one I seen on ebay too ^ , dose anyone have that one?

rat55chevy any pics of that griffin cup holder?

engine2

I dont have that one, but will probably buy it in the near future. It seems to not make a permanent damage for install and you can put different holders onto it for the future. I have not seen a better one yet, but open to suggestions as well. PM me if you find a better solution.

rat55chevy

Website for the Griffin:

http://www.griffintechnology.com/products/isqueez/

ockevin

I saw that ipod holder at the dealer the other day....Like $12.95

larry_chip

i like the one on ebay the most, the griffin looks cheap, the one on ebay looks like it came with the truck.