sselzer09

hello and thanks for reading, i have a 2002 chevy suburban that im installing a clifford 5102 alarm and remote start. where i am running in to a snag is with the remote start part i have the direct tecs wiring sheets and the remote start owners and install manual. when i installed and hit the remote start button all of the accessories come on but the truck never cranks. also ifi start the truck with the key the alarm siren will chirp. here is what wires i hooked up to the ignition harness.

o H3/1 Pink (+) Ignition 1 Out & Ign 1 input sense to IGN C6 (Pink) AND DKPLGM Pink
o H3/2 Red/Wh (+) Ignition 2 to IGN D2 Red/Wh
o H3/3 Orange (+) Accessory to IGN D1 Orange
o H3/4 Violet (+) Starter Out to IGN Yellow C1 (harness side of cut wire)
o H3/5 Green (+) Starter In to IGN Yellow C1 (key side of cut wire)
o H3/6 Red (+) Ignition 1 In to IGN B5 Red (12V constant)
o H3/7 Pink/Wh (+) Ignition 2 Out to IGN C5 Pink/Wh
o H3/8 Pink/Blk (+) Flex Relay In N/A
o H3/9 Red/Blk (+) Accessory In to IGN B5 Red
o H3/10 N/C



not sure whats wrong with my install?




ps i am using the dball bypass and the shop i got the alarm from programed it to a 02 suburban


thanks for any help on this