Mr. Dude with a face's Photos

View Profile

In this photo I was just pointing at a clean spot. It is because this fuel pressure regulator is bad. I have the manifold off to replace the fuel injector spider. You can see how dirty it is. I think there is even a little oil in some spots.

In this photo I was just pointing at a clean spot. It is because this fuel pressure regulator is bad. I have the manifold off to replace the fuel injector spider. You can see how dirty it is. I think there is even a little oil in some spots.

0 2025/04/10 21:13:29 Mr. Dude w

0 2025/04/10 21:13:24 Mr. Dude w

I have 2 20’s in mine. One of them is in that spot labeled for a 30. Everything works fine.

I have 2 20’s in mine. One of them is in that spot labeled for a 30. Everything works fine.

0 2021/12/24 17:56:01 Mr. Dude w

2x4 propping brake pedal with moderate force.

2x4 propping brake pedal with moderate force.

0 2021/11/27 18:11:26 Mr. Dude w

We disconnected this connector from the ABS hydraulic unit. We also pulled the fuse.

We disconnected this connector from the ABS hydraulic unit. We also pulled the fuse.

0 2021/11/27 18:10:43 Mr. Dude w

Approximate level at which the truck was positioned.

Approximate level at which the truck was positioned.

0 2021/11/27 18:10:16 Mr. Dude w

0 2021/11/27 18:09:14 Mr. Dude w

Here is the aproximate angle of the truck.

Here is the aproximate angle of the truck.

0 2021/11/25 11:46:49 Mr. Dude w

I proped the break pedal down with moderate presure between the seat.

I proped the break pedal down with moderate presure between the seat.

0 2021/11/25 11:46:40 Mr. Dude w

Gauges, Indicators and Engine Warning System 1 of 2

Gauges, Indicators and Engine Warning System 1 of 2

0 2021/11/22 06:58:03 Mr. Dude w

Gauges, Indicators and Engine Warning System 2 of 2

Gauges, Indicators and Engine Warning System 2 of 2

0 2021/11/22 06:57:58 Mr. Dude w

Here is the sticker in my door jamb. And their is also typically a very usefull sticker in the glove compartment with RPO codes. You can find RPO code lists online and decipher the build of your truck.

Here is the sticker in my door jamb. And their is also typically a very usefull sticker in the glove compartment with RPO codes. You can find RPO code lists online and decipher the build of your truck.

0 2021/11/15 06:48:10 Mr. Dude w

High beams look like this (although their is nothing special about these, they should be about the same as factory.

High beams look like this (although their is nothing special about these, they should be about the same as factory.

0 2021/10/11 18:59:50 Mr. Dude w

Low beams look like this

Low beams look like this

0 2021/10/11 18:59:05 Mr. Dude w

Markers look like this

Markers look like this

0 2021/10/11 18:58:29 Mr. Dude w

DRL's that look like this

DRL's that look like this

0 2021/10/11 18:57:33 Mr. Dude w

This is the best picture I could get of the wiring diagram for the headlight system.

This is the best picture I could get of the wiring diagram for the headlight system.

0 2021/10/11 18:08:18 Mr. Dude w

Here is the same thing, but on the passenger side.

Here is the same thing, but on the passenger side.

0 2021/10/11 17:56:11 Mr. Dude w

0 2021/10/11 17:53:16 Mr. Dude w

0 2021/10/11 17:48:55 Mr. Dude w

This is that same Red wire, we are currently looking through where the drivers side blinker would normally be (I took these pictures once I had the grill back on, but it is easier to do with the grill off, which you will already have done after installing the new headlights.

This is that same Red wire, we are currently looking through where the drivers side blinker would normally be (I took these pictures once I had the grill back on, but it is easier to do with the grill off, which you will already have done after installing the new headlights.

0 2021/10/11 17:39:42 Mr. Dude w

This is a picture of the back side of the drivers side headlight, my tools are sitting in the battery tray. Once you have your wire into the engine compartment, it is very easy to find the group of wires that run up to the headlights, and you can run your power wire in this loom.

This is a picture of the back side of the drivers side headlight, my tools are sitting in the battery tray. Once you have your wire into the engine compartment, it is very easy to find the group of wires that run up to the headlights, and you can run your power wire in this loom.

0 2021/10/11 17:36:50 Mr. Dude w

Here is that same Red wire, from inside the truck, above and to the left I belive their is a cable that goes through the firewall, you can pop it out and run the wire next to it. Also pictured, on the left, you can see a little bit of the back side of the fuse panel where the wiring was done inside the truck, the screws are in the area around the white block.

Here is that same Red wire, from inside the truck, above and to the left I belive their is a cable that goes through the firewall, you can pop it out and run the wire next to it. Also pictured, on the left, you can see a little bit of the back side of the fuse panel where the wiring was done inside the truck, the screws are in the area around the white block.

0 2021/10/11 17:32:35 Mr. Dude w

0 2021/10/11 17:25:23 Mr. Dude w

Here is the Purple and the Tan wire connected, in this configuration, these wires are in no way connected to the DRL relay anymore. I just want to be clear which half of the newly severed wires get connected to what.

Here is the Purple and the Tan wire connected, in this configuration, these wires are in no way connected to the DRL relay anymore. I just want to be clear which half of the newly severed wires get connected to what.

0 2021/10/11 17:11:12 Mr. Dude w

Here are these two wires cut, the Tan and the Purple. DO NOT CONNECT THE ONES COMEING OUT OF THE RELAY IN THIS PICTURE. You want to connect the ones going up behind the dash to complete the circuit. Connecting this half of these wires will do nothing. But one of these pictured wires coming out of the relay will be used, but in a latter step.

Here are these two wires cut, the Tan and the Purple. DO NOT CONNECT THE ONES COMEING OUT OF THE RELAY IN THIS PICTURE. You want to connect the ones going up behind the dash to complete the circuit. Connecting this half of these wires will do nothing. But one of these pictured wires coming out of the relay will be used, but in a latter step.

0 2021/10/11 17:02:56 Mr. Dude w

0 2021/10/11 16:56:56 Mr. Dude w

0 2021/10/11 16:44:25 Mr. Dude w

Hopefully you can zoom in on this picture, but I redrew what the new wiring would look like.

Hopefully you can zoom in on this picture, but I redrew what the new wiring would look like.

0 2021/10/11 16:08:20 Mr. Dude w

0 2021/06/21 18:54:51 Mr. Dude w

0 2021/06/21 18:53:33 Mr. Dude w

The RPO code sticker in my glove box.

The RPO code sticker in my glove box.

0 2021/01/31 20:21:30 Mr. Dude w

Same story, but now it is in drive. 500 - 600 RPM.

Same story, but now it is in drive. 500 - 600 RPM.

0 2020/09/22 14:47:18 Mr. Dude w

Idle after a few minutes, as you can see this is in park.

Idle after a few minutes, as you can see this is in park.

0 2020/09/22 14:46:32 Mr. Dude w

.052" gap, I am not sure what it supposed to be.

.052" gap, I am not sure what it supposed to be.

0 2020/09/22 14:46:03 Mr. Dude w

I think this is from cylander #3 i think.

I think this is from cylander #3 i think.

0 2020/09/22 14:45:31 Mr. Dude w

0 2020/09/22 14:45:08 Mr. Dude w

Same plug, different angle.

Same plug, different angle.

0 2020/09/22 14:44:32 Mr. Dude w

0 2020/09/22 12:29:09 Mr. Dude w

Page
1 of 2

Go To
Page

Go to page of 2 pages

1
2