Hard to start, sometimes dies while braking and putting it in reverse
#1
CF Junior Member
Thread Starter
Join Date: Dec 2006
Location:
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Hard to start, sometimes dies while braking and putting it in reverse
I have a 99 Silveerado (new body) 4.8L, Automatic. Occasionally it will take 2 or 3 cranks to get it started and sometimes I have to feather the throttle and it will fire. Most of the time it starts just fine.
Also in the past week the engine has died 3 times during an abrupt stop. Basically when you hit the brakes hard it dies (not every time though).
Last, thinking back over the past year or so my engine has died a few times when I put the tranny in reverse.
All of the above problems happen at random times.
Also in the past week the engine has died 3 times during an abrupt stop. Basically when you hit the brakes hard it dies (not every time though).
Last, thinking back over the past year or so my engine has died a few times when I put the tranny in reverse.
All of the above problems happen at random times.
#2
RE: Hard to start, sometimes dies while braking and putting it in reverse
Possible bad brake booster? I had idle problems with my blazer and it would come close to dying sitting at a stop. It came up with a mass air flow code. I replaced the booster and it's fixed. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
akchev
General Tech
3
July 13th, 2011 3:05 AM
wildboy74ss
Silverado & Fullsize Pick-ups
2
April 1st, 2009 5:10 PM
silverado man
Silverado & Fullsize Pick-ups
2
May 5th, 2008 11:53 AM