Need help identifying a drive shaft
Thread Starter
CF Beginner
Joined: Feb 2015
Posts: 4
Likes: 0
Need help identifying a drive shaft
I need some guidance on a drive shaft for my current project (’53 5-window Pickup / LS engine Swap). I’m installing a gen IV LS engine with a 6L80 transmission from a 2013 Silverado. I have a good source for almost any used drive shaft, but I need to identify my requirement by model/year, not drive shaft dimensions.
To match the transmission, I need a shaft with a 32 spline slip yoke - GM 23251196 (Tahoe, Yukon, Escalade. Yukon XL, Suburban. Express, savana. Escalade EXT. Escalade ESV. All models. Avalanche. Hummer H2.) with a 4L80 / 6L80 transmission. As long as it is over 60” long (probably not standard cab, standard bed), I can have the shaft shortened. Also, the differential end u-joint cradle is not critical.
I do want to keep the driveshaft diameter 3’ or less if possible. (and obviously one-piece shaft).
Anybody have experience/suggestions?
To match the transmission, I need a shaft with a 32 spline slip yoke - GM 23251196 (Tahoe, Yukon, Escalade. Yukon XL, Suburban. Express, savana. Escalade EXT. Escalade ESV. All models. Avalanche. Hummer H2.) with a 4L80 / 6L80 transmission. As long as it is over 60” long (probably not standard cab, standard bed), I can have the shaft shortened. Also, the differential end u-joint cradle is not critical.
I do want to keep the driveshaft diameter 3’ or less if possible. (and obviously one-piece shaft).
Anybody have experience/suggestions?
Thread
Thread Starter
Forum
Replies
Last Post
