trying to ressurect 1988 beretta with a 2.0L i4. have dropped/cleaned fuel tank, replaced entire fuel pump assembly, replaced spark plugs, ignition coils, and wires, oil pressure sensor, cleaned out throttle reservoir and injector, no fuel or spark problems whatsoever, no compression problems, car will virtually crank but will not run. have tryed everything.

any suggestions or tips???

 

could this have anything to do with the ignition module? does this tend to go out with time?

 

Where are u located maybe i can u outi

 

Are you sure there is no fuel or spark problems?

I know these cars had a water leak, maybe the ECM is not turning on?

Do you get a valid signal from the CPS?

Are you sure there is not a bad injector? if one goes, they all get shut off by the ECM to protect itself.

Bad coil?

Something is not working if it cranks and won't start.
Maybe its too rich?

Check the CPS, many times if that is bad, the engine will not run at all...

any more info will help.