More driveshaft problems
Thread Starter
CF Beginner
Joined: Jun 2018
Posts: 3
Likes: 0
More driveshaft problems
1981 k10 - cannot get slip yoke to slide into transfer case, when I hammer it out finally makes loud pop noise as if there’s a vacuum created by rear output seal. I cannot get it to slip far enough in, has anyone heard of this happening? Thanks for the help
CF Monarch
Joined: Oct 2017
Posts: 4,605
Likes: 268
From: USA
There should be no vacuum as transmissions and transfer cases have a vnrt or vent hose to maintain atmospheric pressure of the unit operating..
Last edited by oilcanhenry; Jun 9, 2018 at 10:30 AM.
Thread Starter
CF Beginner
Joined: Jun 2018
Posts: 3
Likes: 0
Thanks for the help. what could be stopping the yoke from going in the slip yoke is fine and so is the rear output shaft. It slides on for a few inches and then stops but it’s not bottomed out. I can hammer it in with a mallet but I don’t know if that’s a stupid thing to do or not.
