Panefull

Hello there people's..........I have a 82 c2500 with 700r4 with the original 350 engine ...looking to freshen it up a little. I have had the bottom end all done new and the factory heads are all redone ....so I'm wondering about a cam selection to go with a edelbrock airgap intake with a impact 450 cfm on top ... I already have headers for it and will do dual exhaust also.......and kinda curious about maybe running some 1.6 rockers on her to but I am getting mixed info about running them with the stock pressed in studs???....I don't mind putting in a stall to compensate for a larger cam that would take advantage of the propane......so any info would be appreciated..... Oh and yes this is a daily driver and weekends I tow hard with the travel trailer..........thanks everybody........

SWHouston

As many times as I've herd of a Stud slipping, I'd address that issue regardless of what lift Cam or Rockers you used !

kevinkpk

X2. Since I assume your heads are still off, I'd take them to a machine shop that specializes in this matter, they would know what is best.

Panefull

Yup the heads are still off so I can run them back to the machine shop and have the studs done.........thanks

Panefull

Anybody else..........lol