New clutch issue.
#1
New clutch issue.
Hi, I am Brian and this is my 1st time ever using any discussion forum. Take it easy on me.. Lol
I have a new clutch, pressure plate, throw out/slave cylinder, clutch master cylinder, clutch pedal and flywheel has been turned down on my 2006 Chevy Silverado 1500 4.8l 5 speed.
I bench bled the master til rod was hard and would not move, gravity bled slave. Installed everything and have bled through 2 bottles of 32 oz DOT3 fluid. It drives but hard to go in gear and barely disengages where soon as you start letting off clutch it goes. Also at idle still sounds like a bad throw out/slave with the rattle noise they make but when clutch is pushed in and put in first it goes away. It is my 2nd new slave i have installed. Any suggestions before I take it to a shop.
I have a new clutch, pressure plate, throw out/slave cylinder, clutch master cylinder, clutch pedal and flywheel has been turned down on my 2006 Chevy Silverado 1500 4.8l 5 speed.
I bench bled the master til rod was hard and would not move, gravity bled slave. Installed everything and have bled through 2 bottles of 32 oz DOT3 fluid. It drives but hard to go in gear and barely disengages where soon as you start letting off clutch it goes. Also at idle still sounds like a bad throw out/slave with the rattle noise they make but when clutch is pushed in and put in first it goes away. It is my 2nd new slave i have installed. Any suggestions before I take it to a shop.
Last edited by Brian Simmons; April 14th, 2018 at 5:17 PM. Reason: Did not introduce myself