Hi, new to the forum and looking for some help! I have a 1963 Chevy Panel Truck that I'm building from the ground up to lay on the ground. It's bodydropped on 84 axles. I am running a drivetrain from a 95 RV which was based off a G30 van. It had a TBI 350 with a 4L80E tranny.

I have the drivetrain in my 63 and have it running with the 95 RV column laying on the floor. I need to wire the ignition from the g30 harness into the ignition of the 63. I also need to wire in the turn signals. The rest I think will work.

Can anyone help me with a wiring diagram of the ignition and turn signals for a g30 van or truck equivalent? I'm guessing the wiring is pretty similar if not the same for a 95 truck with TBI.

Thanks in advanced.
Here's a pic of my panel truck.

 

Welcome.

 

Welcome to the forum.

If you post your request in the truck section.

 

I posted in the van forum but nobody responded. Thought maybe if I posted here maybe someone would help out.