Steering wheel off centre after pitman arm replacement
#1
Steering wheel off centre after pitman arm replacement
Replaced pitman arm and idler arm on my 99 Sonoma. Steering wheel is now about a quarter turn off. Given that the pitman arm and the idler arm can only go on one way , I know the installation is not the problem. Why is the steering off by so much? The only conclusion I can draw is that during manufacture (probably in China), the splines were cut a few degrees off. Comments?
Update. Was able to bring my steering wheel closer to centre by adjusting tie rods. Going for an alignment on Wednesday. I thought I had a bad part or a wrong part but I was worried for nothing. Its all good.
Update. Was able to bring my steering wheel closer to centre by adjusting tie rods. Going for an alignment on Wednesday. I thought I had a bad part or a wrong part but I was worried for nothing. Its all good.
Last edited by sceptre123; September 12th, 2022 at 9:59 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Edward Andriaccio
Express, Savana & G-Series Vans
10
March 6th, 2022 11:57 AM
hoffa
Silverado, Sierra & Fullsize Pick-ups
3
July 12th, 2011 11:54 AM