Has anyone else had this problem with heat not blowing out of the passenger side even when set to 90? I have been to the dealer 5 times now as of today. I even have changed dealers. They have relearned all the blender doors 4 times and today they replaced the entire control board and still tonight blowing cold air. The drivers side has been blowing the correct temperature the whole time.

I don't see anyone else with the same problems.

Anything the dealer should still check?

 

Never had the problem but i would have to wonder if the sensor is working correctly?

 

Mine did this too a few times... then it stopped for some reason... the dealer was clueless as they normally are.