Hi,

I just got done installing a Kenwood DNX9990HD, easier than I thought it was going to be. What hasn't been easy is finding information on how the factory camera is wired to the rear view mirror. I would like to reroute the video signal to the Kenwood.

I have seen some other posts that talked about certain wires in the A Pillar, however it seems GM may have changed that up a bit. What I see are several unwrapped wires and then what appears to be a set of wire wrapped in a foil like sheathing.

Whould that be the wires I am looking for? I just don't want to mess with it if it isn't what I am after.

Any help would be appreciated!

 

I can't say for sure without looking at a diagram for those cables, but foil wrapping is typically used to shield the wires from radio interference (electrical noise)... so yes, in my opinion those are likely the wires...