96 2.2 auto in limp mode, cel on, esc on
December 6th, 2011, 11:18 AM
#12
My bad.
I was going to say right side of the engine (with the front of the engine being where the pulleys are) but I thought that could be taken wrong. Your "firewall side" is correct.
I was going to say right side of the engine (with the front of the engine being where the pulleys are) but I thought that could be taken wrong. Your "firewall side" is correct.
December 6th, 2011, 11:43 PM
#13
CF Beginner
Thread Starter
Join Date: Nov 2011
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
fantastic! i was beginning to wonder if id ever find it. now weather permitting and since i have the new part i should have it installed this weekend. from what ive seen im thinkn the only way to do this is to remove the intake manifold so i can see what im doing down there. will this one part truly cause the symptoms i have described to you? i am really hoping so
December 7th, 2011, 11:56 AM
#14
Put it on a ramp or jack stands and get to it from below? It's actually on the passenger side (see updated image in my post #9). What I had before (KS on the driver side) was for 2.4L. As for P0325, it could be the sensor or wiring (actually a single wire that goes to PCM connector C3, terminal 27.
Thread
Thread Starter
Forum
Replies
Last Post
j460torino
Silverado, Sierra & Fullsize Pick-ups
0
April 5th, 2011 6:27 PM
76Fiorenzo
Silverado, Sierra & Fullsize Pick-ups
0
November 7th, 2010 10:29 AM
bweers
Silverado, Sierra & Fullsize Pick-ups
2
December 15th, 2008 12:05 PM
