Tranny governor was broke, replaced it truck still would not shift on the ground. but if I picked up the rear end, it would shift into every gear and the tires would move but as soon as I put it back on the ground. It won’t go everybody was saying it’s my clutch plates, but would a governor would not the right teeth do that? I don’t want to rebuild this tranny if it could be the wrong size governor.

 

Governor was broke . Question is , would a different size govenor make it do this after putting on new one ? I put rear end up on jacks , it shifted fine in every gear . tires spinning faster as I accelerated, but as soon as i put it back on the floor and tryed putting it into gear-it did nothing , not a budge. I had a couple people say its the clutch plates. I dont want to rebuild this tranny if it was something that simple . And i need this truck running it my only vehicle

 

Please do not multi-post the same question.
Forum rules are posted for your convenience in the Welcome section. See #4.

(topics merged)

 

Welcome to the forum. You need to put your post in the section of the forum dealing with '66 Chevys, cars or trucks.

 

Shark is right. You posted in "Forum Notices" which nobody is going to see. Moving it to general until you post the vehicle.

 

thanks I didn’t understand still kinda don’t thank you for putting it where it goes