Looking to find out how to remove the dash to replace the stock radio. Any pixs or how too's would be much appreciated!
I posted this also in the audio section but thought that I would get more help from this forum.

Thanks,
HDFXRUSA

 

hi there,
the dash cover consist of a few screws and 2 push pins for the removal of the handbar on the passanger side. open your door on the side there are cover take them off u will see 2 screws undo them on both sides.take your air vents out on the passanger side with a flatblade screw driver nothing special just pull them out u have to reach inside there is a push pin located in there just push and pull bar outwards at the same timethis goes for both sides ok.remove your dash bezel by pull it outward there are no screws involved in removing it.When you look behind the bezel you just removed there are about 6 screws or 7mm nuts holding ur dash on ,just take em out and ur pretty much done.remove both pillars by prying them off and outwards.then u can pull forward on your dash cover to remove but dont pull too far you will have to undo the

[IMG]local://upfiles/8968/AC0D04C4ADFE4069BF5ACADB803D969F.jpg[/IMG]

 

........undo the light sensors on the dash cover in the front by windshiled.here is a few pics i took for ya ok so its better to understand bu tit is quite simple to do really so dont stress it out ok.

[IMG]local://upfiles/8968/D08EA000460D43A5A2E9A248118223B2.jpg[/IMG]

 

Thanks for the info! I am sure it will not be a problem.

HDFXRUSA

 

hello, i am gonna replace radio in a 02 sub. do you have remove dash cover or just dash face to replace radio? jon

 

hdfxrusa - you don't need to remove all that stuff to remove the radio.
turn the key on, put gear shifter all the way down, tilt steering wheel all the way down, and just pull off the panel srounding the radio, hvac controls and intrument cluster. then remove the3 7mm bolts to remove radio

hopeless - your dash is exactlythe same. The only difference in removing the radio is that yours is just clipped in.

 

shawn, thanks for reply. will change it this weekend. hopelesssinner

 

[quote]ORIGINAL: shawnvw

hdfxrusa - you don't need to remove all that stuff to remove the radio.
turn the key on, put gear shifter all the way down, tilt steering wheel all the way down, and just pull off the panel srounding the radio, hvac controls and intrument cluster. then remove the3 7mm bolts to remove radio

Thanks shawnvw for the reply!
HDFXRUSA

 

sorry wasnt sure if u were installin a indash tv or a regular din cd player.

 

hello i need to replace my ac vent actuators and believe they are hiding under the dash cover,, i read the post but was hoping to get some pics or additional info on how to remove the dash cover,,, i just dont want to snap anything or have rattles putting it back together

thanks