Getting wiring in and out of an '07
#1
CF Active Member
Thread Starter
Join Date: Jan 2007
Location: Northern galactic plane of Andromeda
Posts: 171
Likes: 0
Received 1 Like
on
1 Post
Getting wiring in and out of an '07
I'm planning to install a lot of 2 way radio gear (ham gear) in my '07 Tahoe. Are there any good places on the firewall to bring wiring and coaxial cable from the engine compartment to the interior?
#2
RE: Getting wiring in and out of an '07
GOOD LUCK! Unless you drill one there really isn't a good place. But I will tell you where a gromet is. If you follow the cable for your parking brake, it goes under the carpet to a gromet you can slit to allow a wire to pass. Just seal it up with some Silicone RTV. If I were you, I'd run a 12 guage wire to a distribution block.
#6
RE: Getting wiring in and out of an '07
ORIGINAL: Hardin Thicke
I'm planning to install a lot of 2 way radio gear (ham gear) in my '07 Tahoe. Are there any good places on the firewall to bring wiring and coaxial cable from the engine compartment to the interior?
I'm planning to install a lot of 2 way radio gear (ham gear) in my '07 Tahoe. Are there any good places on the firewall to bring wiring and coaxial cable from the engine compartment to the interior?
http://service.gm.com/techlineinfo/radio.html
Thread
Thread Starter
Forum
Replies
Last Post
Derek2023
Tahoe & Suburban
16
July 17th, 2007 12:04 AM