Grinding sound when reversing and turning.
Thread Starter
CF Beginner
Joined: Sep 2019
Posts: 1
Likes: 0
Grinding sound when reversing and turning.
Hello forum,
My car is a 2011 suburban 4x4 with 100k. This past week I purchased new tires for it and noticed a new sound: when I reverse doing a tight turn to the right it makes a sort of grinding noise. I inspected the tie rods, ball joints and cv joint as well as hub for bad bearings and I could not pin point any obvious problems. It only happens when turning in one direction. I took 2 videos to try to show the sound. I am going for my state inspection soon and will ask my buddy if he has an idea. Figured this forum may be a good place for advice. To clarify it is NOT in 4x4 (and I never use it on dry pavement). And it has only started recently. In the interior video you can hear it perhaps a little louder than the exterior video.
Regards,
Mike
My car is a 2011 suburban 4x4 with 100k. This past week I purchased new tires for it and noticed a new sound: when I reverse doing a tight turn to the right it makes a sort of grinding noise. I inspected the tie rods, ball joints and cv joint as well as hub for bad bearings and I could not pin point any obvious problems. It only happens when turning in one direction. I took 2 videos to try to show the sound. I am going for my state inspection soon and will ask my buddy if he has an idea. Figured this forum may be a good place for advice. To clarify it is NOT in 4x4 (and I never use it on dry pavement). And it has only started recently. In the interior video you can hear it perhaps a little louder than the exterior video.
Regards,
Mike
Thread
Thread Starter
Forum
Replies
Last Post
lsxstreetcars
Show Off Central
3
Feb 19, 2017 5:57 PM