2000 Chevy Express cranks but won't start.
I also replaced Crank position sensor,
map sensor, ignition control module.
I replaced The battery because the old one did have a bad cell.
I checked the distributor and it appear to be OK.
I rotated the engine so that number one cylinder is at TDC, then checked the distributor and it is pointing to number one.
When I try to start the vehicle it appears to backfire through the intake.
map sensor, ignition control module.
I replaced The battery because the old one did have a bad cell.
I checked the distributor and it appear to be OK.
I rotated the engine so that number one cylinder is at TDC, then checked the distributor and it is pointing to number one.
When I try to start the vehicle it appears to backfire through the intake.
Did you check voltage on pink wire at ignition coil module? Use a test light and check with engine cranking. That circuit is fuse protected, the fuse is in underhood fuse box, ign/inj fuse.
Thread
Thread Starter
Forum
Replies
Last Post
artimious7
Silverado, Sierra & Fullsize Pick-ups
9
Dec 15, 2020 5:10 PM
jeff739
Express, Savana & G-Series Vans
2
Jan 19, 2020 9:40 AM
BuyOuts
Express, Savana & G-Series Vans
0
Nov 10, 2009 8:16 AM



