I had recently replaced the ign cylinder because
the one before was worn out.. but later on
I lost the keys, I had someone drill out the ign cylinder hole
keyway with a drill.. I then installed a used ign cylinder,
leaving the key in the run possition for 10min until
the Theft light would stop blinking solid.. but
the Theft Light was not blinking on & off just solid on..
so the 10 min were over I proceeded to start the engine
the car did start for a few seconds but the engine shut off
so I did the 10min all over again, but it was useless because
the ign cylinder cant be reprogrammed idk why????
can someone help me????